Minelab F1A4 Manual de servicio descargar pdf (Pagina 15)

Operations Manual

Page 15

4.3 Armrest (see Figure 6)

To assemble the armrest:

a. Insert the sharp end of the arm strap through one of the slots at the

base of the armrest, then through the slots at the top of the wings of

the armrest. When the operator“s arm is in the armrest, the

protruding part of the –Velcro“ strap should be fixed to make a firm

fit.

b. Decide whether the Control Box is to be attached to the handle or

housed in the control box bag, as this will determine what length of

coil should protrude from the main shaft.

c. If the Control Box is to be attached to the shaft, position the cable

grommet closest to the plug end of the coil cable into the keyway

beneath the camlock at the top end of the upper shaft. (Surplus coil

cable can be stored inside the hollow main shaft.)

d. Alternatively, if the Control Box is to be carried in its shoulder pack,

position the grommet located between the two curled sections of the

coil cable into the keyway beneath the camlock at the top end of the

main shaft.

e. When the appropriate grommet is positioned in the keyway, push

the end of the armrest assembly into the camlock on the top of the

main shaft and clamp using the upper camlock lever.

NOTE:

It is not necessary to pull the cable through the top of the main shaft if

the control box is to be connected to the handle. However, if the cable

is pulled through, twisting the coiled section of the cable to ”tighten— the

coil will make reinsertion of the cable easier. This technique simplifies

shaft reassembly.

PDF created with FinePrint pdfFactory trial version http://www.fineprint.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Sin comentarios

Minelab F1A4 Manual de servicio Pagina 15