Minelab F3 Manual de servicio descargar pdf (Pagina 22)

F3 Field Service Manual

Page 22

● Remove the top half of the speaker pod by lifting the pod gently upward until the

speaker pod plug comes clear of the handle.

● Using fingers support the main wiring loom socket against the lower half of the

speaker pod and disconnect the speaker pod plug from the main wiring loom.

NOTE

Do not try and remove the loudspeaker, ground balance/audio reset button or wiring from the

upper half of the speaker pod, these components are permanently sealed into the upper half

of the speaker pod.

● Remove the screw (Part 4) (Figure 25) which secures the lower half of the speaker

pod to the handle. The nut for this screw sits in a recess between the two handle

halves. This screw is a unique screw and cannot be used on any other part of the

detector.

Figure 25: Lower Section of Speaker Pod Showing Unique Screw (Part 4)

● Remove the lower half of the speaker pod by lifting the rear of the pod upwards.

b. To replace the speaker pod. When replacing or reassembling speaker pods it is

important to note that an F3L speaker pod is only functional on an F3L configured detector.

Similarly, the standard F3 speaker pod is only functional on the F3 detector. To reassemble

the speaker pod:

● Ensure that the handle has been fully assembled and the wiring loom is in place.

(See Section 3.6)

● Peel back the shroud at the end of the speaker pod plug as shown in Figure 26.

Figure 26: Upper Shell of Speaker Pod Showing Shroud Peeled Back

● Refit the lower half of the speaker pod by inserting the tongue at the front top of the

handle into the recess in the lower half of the speaker pod. (Figure 27)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Sin comentarios

Minelab F3 Manual de servicio Pagina 22