Minelab F3 Manual de servicio Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 42
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
F3 Field Service Manual
Page 35
Figure 48: Upper Camlock Positioned on Upper Shaft
Place the tail of the upper pressure block into the recess in the rear of the upper
camlock body and push the block down into the square hole. (Figure 49)
NOTE
Ensure that the pressure block does not protrude too far into the shaft. If necessary push it
back into the camlock body otherwise difficulty may be encountered when fitting the middle
shaft.
Figure 49: Reassembling the Upper Camlock Assembly
Hold the cam lever in place whilst the cam lever pivot pin is pushed into the camlock
body.
Open the upper cam lever.
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42

Comentarios a estos manuales

Sin comentarios