Minelab F3 Manual de servicio descargar pdf (Pagina 31)

F3 Field Service Manual

Page 31

3.8 Armrest. Figure 42 illustrates the major parts of the armrest

8013-0002 ARMREST ASSEMBLY F3

1 4002-0023 NUT M4 NYLOC SS

2 4003-0063 BOLT M4X30 SKT SS

3 4308-0003 CAMLEVER PIVOT PIN

4 3004-0015

LEFT ARMREST HALF (part of ARMREST L+R

F3)

5 3004-0015

RIGHT ARMREST HALF (part of ARMREST

L+R F3)

6 8008-0005 CAM LEVER F3

7 8008-0026 PRESSURE BLOCK ARMREST F3

8 8008-0030 WEAR PLATE F3

9 8005-0018 STRAP ARMREST F3

Figure 42: Armrest Component Parts

a. To disassemble the armrest:

● Unlace the armrest if required.

● Undo and remove the three bolts and nuts holding the armrest halves together.

● Carefully pull the armrest halves apart exposing the cam lever, (Part 6), cam lever

pivot pin (Part 3), and armrest pressure block (Part 7).

● Inspect and replace parts as required.

b. To assemble the armrest:

● Position the right half of the armrest onto the upper shaft.

● Fit the armrest pressure block, cam lever pivot pin and cam lever into the right

armrest half.

● Carefully fit the left armrest half to the right armrest half and upper shaft.

● Refit the three bolts and nuts.

NOTE

If the armrest is difficult to slide on the upper shaft, the middle bolt may need to be loosened.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Sin comentarios

Minelab F3 Manual de servicio Pagina 31